| |
| | |

Printer Forum   

 Forgot password?
 register
Search
View: 488|Reply: 1

where is the ctd sensor located on fuji xerox docuprint cm

[Copy link]

Post time: 2012-6-11 11:48:48 |Show all posts
where is the ctd sensor located on fuji xerox docuprint cm205w
Optional Information:
Make: FUJI XEROX
Model: DOCUPRINT CM205FW
What have you tried so far?: Talking to an online helper who has no idea either.Also I have turned the printer off at the unit and the wall for one minute.I have replaced all the toner cartridges.Error message is:Check the CTD Unit.092-310Clean the CTD sensor
        

Post time: 2012-6-11 13:35:25 |Show all posts
Hi my name is Colin
The CM 205 range share the same chassis pretty much, the FW has an Auto Doc feeder for the scanner but otherwise they are much the same. I have linked the manual at the bottom of my answer for you. It contains the CTD info on page 443 and i have repeated it below for speed.
That error in effect indicates a poor reading from the Density sensor. When that occurs the printer requests the sensors are cleaned (there are 2 in the Cm205). Whilst cleaning it in most occasions will fix the issue it's not a 100% cure if the problem is a sensor fault.
The location is within the rear access door of the printer as shown in the picture below. Clean them with something clean and dry like a cotton swab. Don't use any fluids or chemicals as this may damage the sensor. Do this with the power off on the printer and all being well the error will clear at next use.
User manual - http://www.fujixeroxprinters.com.au/downloads/uploaded/Karin_IBG_Aio_4in1_ENG_w_9553.pdf
If you have questions let me know.
You have to log in before you can reply Login | register

Advertise on OASQ.COM| Contact us| Archive| OASQ

2014-9-2 15:40 GMT-8

Powered by Discuz! 7.2

Release 20121101, © 2001-2014 OASQ.

To Top